Sun. Jun 23rd, 2024

Tired off exploring various websites for an optimal solution to fix not working issue?


Then, your search is over here. In this article, we have tried our best to explain all the router login troubleshooting steps in a handy and simple manner.


What’s Inside the Article?


The article includes fixing to Netgear router login issues like:


  • Unable to visit the Netgear router login web page.
  • Unable to connect to
  • Cannot connect to
  • How to set up Netgear router
  • WiFi issues like Netgear router did not connect to the Internet.


So, let’s make a clean sweep over these aforementioned Netgear router issues.


How to Remove not Working Issue?


Here is the complete set of fixes that will help you to solve and get logged into your Netgear Nighthawk router.


  • Firstly, check the power LED on your Netgear router. It should not be red or blinking.
  • If the LED light is blinking, try to update the Netgear router’s firmware.
  • If you find red or no power LED light, you must try to troubleshoot the router WiFi network.


However, if your router’s light is ON, it means your WiFi router is working fine. Thus, to fix the not working problem, you must have to follow the below-mentioned steps:


  • Check your router is connected well with the modem.
  • Further, ensure you are typing the correct IP address in the web browser to visit the Netgear router setup web page.
  • Ensure that you are typing correct Netgear router login credentials while accessing the  web page.


However, there are a lot of reasons, for routerlogin not working. To understand and fix them follow the below-mentioned norms:


  • Scan your computer to identify and remove any virus or malware if any.
  • Try to use a different web browser to check if the issue is related to your web browser or Nighthawk router.
  • Still, the problem persists, try to reset your Netgear router back to default factory reset settings.


A Few More Solutions to Solve not working Issue


If with the above steps, you are unable to open the router login web page, then go with the following fixes:


  • Disable any VPN or proxy servers running on your computer. Visit the ‘Network and Sharing Centre’. Now, check for the enabled proxies, and then choose the ‘Disable’ option.
  • In most of the cases, pop-up blockers can also be the factor behind the failure of router login. So, try to disable them and check if it fixes your error.
  • The next fix is to clear the DNS cache of your computer via using a command. Press Windows + R key and type CMD in the box. Hit on the ‘OK’ button. Now type ‘ipconfig/flushdns’ and hit the ‘Enter’ key.


If still, the problem persists, try to reset your Netgear WiFi router. You can also reach us through us via comments. We are always here to assist you with some of the best fixes related to the Netgear router.

By admin

Leave a Reply

Your email address will not be published. Required fields are marked *