Are you getting red light error on your Linksys WiFi range extender? Waited enough for the red light to turn green but no result? In the event that the red light on your Linksys extender is not turning green, it means that your device has been stuck into some issue. To fix this, you need to follow some troubleshooting hacks. This piece of writing sums up various fixes to troubleshoot Linksys extender red light issue. Let’s get started, shall we?
Fix Linksys Extender Red Light Issue
Turn Your Linksys Extender Off and On Again
If your Linksys extender keeps on showing red light error and you are unable to fix it, consider power cycle or reboot it. To initiate the process, walk through the instructions highlighted below:
-
Unplug your Linksys extender from the power source.
-
Wait patiently for some time.
-
Plug in your Linksys extender back.
Thus, with the help of this process, you may give a halt to Linksys extender red light issue.
Place Your Linksys Extender in a Ventilated Location
Perhaps, due to overheating, the LED on your Linksys extender will not turn green. To cope up with this issue, place your Linksys extender in a higher and airy location. While placing your Linksys extender, make sure to place it in reach of your router.
Are you receiving full WiFi signals? Check this out by turning on your PC or laptop and access the Linksys WiFi setup page.
Check for Signal Interference
While relocating your Linksys extender, it is important for you to know that, placing it in a corner or reach of neighboring WiFi networks might give you red light issue. The only way out to fix the Linksys extender red light issue is to place it at a location where there is least interference.
Replace the Ethernet Cable
At times, you may face issues with your Linksys extender due to damaged Ethernet cable. So, check the Ethernet cable you have used to connect your Linksys extender and router. If you find any cuts or damages on your Ethernet cable, replace it right away or you can also use a wireless connection to connect your Linksys extender and router.
Set up Your Linksys Extender
On the off chance if you have left the Linksys WiFi extender setup incomplete or not performed it properly, then also you may face red light issue. So, if you are in awe of the red light issue, configure your Linksys extender in a proper manner.
Update the Linksys Extender Firmware
A regular firmware update helps in upgrading your Linksys extender with new features and enhanced security. Besides, the latest version of firmware helps in making your device work efficiently in a hassle-free way. To cope up with the red light issue, consider updating the extender’s firmware by navigating to Linksys WiFi extender page using the default IP or the web address.
Note: For the default IP or the web address, refer to Linksys extender manual.
Reset Your Linksys Extender
The last remedy you can try to fix Linksys extender red light issue is to reset it back to factory default values. Doing so will not only fix issues with your Linksys extender but also erase all the personalized settings on it. Once you are done with resetting your Linksys extender, configure it again using the default web or IP address.
Bonus Tip: To revamp your internet experience to the next level, replace your existing router with a new one and connect it to your Linksys extender. Preferably, go with Linksys router and configure it by accessing Linksys router login page. Once done, try connecting it to your Linksys extender and see if it works.
Anticipating that, the hacks given in this post have helped you out to fix Linksys extender red light issue. In case of any doubts, feel free to drop a line into the comments section.